Cleaning And Maintenance; Cleaning External Parts; Cleaning The K-Cup Holder Assembly - Keurig B30 MINI Owner's Manual

SECTION 2

cleaning External Parts

IMPORTANT: Make sure the Brewer is unplugged before cleaning
Regular cleaning of the Brewer's external components is recommended.
Never immerse the Brewer in water or other liquids. The Housing
1.
and other external components may be cleaned with a soapy, damp,
non-abrasive cloth.
The Drip Tray can accumulate liquids. The Drip Tray and Drip Tray Plate
2.
should be periodically inspected and cleaned with a damp soapy non-
abrasive lint free cloth. The Drip Tray and Drip Tray Plate should not be
put into the dishwasher. To remove the Drip Tray Assembly, simply slide
it toward you, keeping it level at all times to avoid spilling.

cleaning the K-cup holder assembly

1. Cleaning the Parts —
1
fig.
Assembly can be placed onto the top shelf of a
dishwasher.
in the dishwasher.
open the cover by pressing the "Press to Open"
button. Grasp the top of the K-Cup Holder with
one hand while pushing up on the bottom of the
K-Cup Holder from underneath with the other
until it releases (fig. 1). After cleaning, align the
K-Cup Holder with the opening using the two
front ribs as a guide, and snap into place from
the top.
Cleaning & Maintenance
The K-Cup Holder
NOTE: Use low temperature cycles
To remove from the Brewer,
2. Cleaning the Funnel —
2
fig.
3. Cleaning the Exit Needle —
!
CAUTION: There are sharp needles that puncture the K-Cup above the K-Cup
Holder and in the bottom of the K-Cup Holder. To avoid risk of injury, do not
put your fingers in the K-Cup Assembly Housing.
NOTE: Over time, discoloration, spotting or staining may appear in the Hot
Water Tank. This is normal and will vary depending on the mineral content of
the bottled or filtered water used in the Brewer and will not affect the operation
of the Brewer.

The Funnel can be
removed from the K-Cup Holder by pulling
on it until it snaps off (fig. 2). The Funnel is
dishwasher safe. To replace it, just snap it
back onto the K-Cup Holder Assembly.
The Exit Needle is
located on the inside bottom of the K-Cup
Holder Assembly. Should a clog arise due to
coffee grinds, it can be cleaned using a paper
clip or similar tool. Remove K-Cup Holder
assembly and detach Funnel. Insert the paper
clip (as shown in fig. 2) into the Needle to
loosen the clog and push it out. The K-Cup
Holder is dishwasher safe.
NOTE: The Entrance
needle does not require cleaning.