Sending A Data Or Fax Call - Motorola V60i User Manual

Do This
3 Plug the other end of the cable into the serial
interface connection on the external device and
tighten the screws.
Attaching a USB Cable
Do This
1 Plug the end of the
cable with the
Motorola logo into the
phone's accessory
connector port. Make
sure that the logo and
the phone are both
facing you.
2 Plug the other end—the USB connection—into
the USB port on the external device.
Install the Software
Install the software from the CD-ROM that comes with
your Motorola Original data kit. See the data kit's user
guide for more information.

Sending a Data or Fax Call

Use this procedure to send data or a fax from a connected
device, and to synchronize phonebook and datebook
information between your phone, computer, and/or
hand-held device.
Connect your phone to the device as described on
page 127 and do the following:
Do This
1 Check the phone make sure that the phone is
2 Open the
3 End the call from
129 130
To
connected and powered on
place the call through the
application on application (such as
your computer dial-up-networking or fax)
Note: You cannot dial data or
fax numbers through your
phone's keypad. You must
dial them through your
computer.
close the call and connection
the connected when the transfer is complete
device