Network Stack; Administrator Password; User Password - Gigabyte GA-B75N User Manual

& Storage Boot Option Control
Allows you to select whether to enable the UEFI or legacy option ROM for the storage device controller.
Disables option ROM.
Disabled
UEFI Only Enables UEFI Option ROM only.
Legacy Only Enables legacy Option ROM only. (Default)
Enables legacy Option ROM first.
Legacy First
UEFI First Enables UEFI Option ROM first.
This item is configurable only when CSM Support is set to Always.
& Display Boot Option Control
Allows you to select whether to enable the UEFI or legacy option ROM for the graphics controller.
Disables option ROM.
Disabled
UEFI Only Enables UEFI Option ROM only.
Legacy Only Enables legacy Option ROM only. (Default)
Enables legacy Option ROM first.
Legacy First
UEFI First Enables UEFI Option ROM first.
This item is configurable only when CSM Support is set to Always.
& Other PCI Device ROM Priority
Allows you to select whether to enable the UEFI or Legacy option ROM for the PCI device controller other
than the LAN, storage device, and graphics controllers.
UEFI OpROM Enables UEFI option ROM only. (Default)
Legacy OpROM Enables legacy option ROM only.
& Network stack
Disables or enables booting from the network to install a GPT format OS, such as installing the OS from
the Windows Deployment Services server. (Default: Disable Link)
& Ipv6 PXE Boot Support
Enables or disables IPv6 PXE Support. This item is configurable only when Network stack is enabled.
& Ipv4 PXE Boot Support
Enables or disables IPv4 PXE Support. This item is configurable only when Network stack is enabled.
& Administrator Password
Allows you to configure an administrator password. Press <Enter> on this item, type the password, and
then press <Enter>. You will be requested to confirm the password. Type the password again and press
<Enter>. You must enter the administrator password (or user password) at system startup and when entering
BIOS Setup. Differing from the user password, the administrator password allows you to make changes to
all BIOS settings.
& User Password
Allows you to configure a user password. Press <Enter> on this item, type the password, and then press
<Enter>. You will be requested to confirm the password. Type the password again and press <Enter>.
You must enter the administrator password (or user password) at system startup and when entering BIOS
Setup. However, the user password only allows you to make changes to certain BIOS settings but not all.
To cancel the password, press <Enter> on the password item and when requested for the password, enter the
correct one first. When prompted for a new password, press <Enter> without entering any password. Press
<Enter> again when prompted to confirm.
- 35 -