Setting Up An Internal Group Call Group; Setting Up Ring Delay - Gigaset S44 User Manual

System settings

Setting up an internal group call group

You can make a group call from any handset to all other registered internal subscribers
(page 24).
By default, all registered subscribers with the device type "telephone" or "neutral" are set
up in the group call group.
¢ ¢
v Ð
Base
s
INT11: Int.11
v
s
Hunt group

Setting up ring delay

Ring delay can be used to individually set up one subscriber per receive MSN to ring
later. During this ring delay time, the handset can take the call using the "Accept?"
function without hearing a ring. The ring delay time is specified in ring cycles. A ring
cycle lasts 5 seconds.
Take into account the response time of the answering machine when making this set-
ting (default: Automatic 2/4). If the set ring delay is longer than the setting for an active
answering machine, the phone will not ring because the answering machine will pick
up the call first.
For each programmed MSN, at least one subscriber must be able to be called immedi-
ately. Therefore, a subscriber set up for ring delay will be called immediately if it is the
only one on this receive MSN, or no one else can be reached on this receive MSN.
Picking up a call during ring delay see page 26.
¢ ¢
v Ð
Base
s
INT11: Int.11
v
s
Ring delay
s
MSN1:
~
OK
110
¢ ¢
Settings Setup user
Select the internal number, e. g. INT 11: Int.11.
Open the submenu.
Select and confirm (‰ = activated).
OK
¢ ¢
Settings Setup user
Select the internal number, e. g. INT 11: Int.11.
Open the submenu.
Select and confirm.
OK
Select receive MSN, e. g. MSN11: Anna
OK
and confirm.
Enter No. of rings.
¢
Setup device
¢
Setup device