Important Safety Information - Robertshaw 9700i User Manual

Deluxe programmable thermostats
Table of Contents

Advertisement

110-1023E.qxd
11/18/04
10:50 AM
Page 2
2

IMPORTANT SAFETY INFORMATION

WARNING:
Always turn off power at the main power source by unscrewing fuse or switching circuit
breaker to the off position before installing, removing, or cleaning this thermostat.
Read all of the information in this manual before programming this thermostat.
This is a 24V AC low-voltage thermostat. Do not install on voltages higher than 30V AC.
All wiring must conform to local and national building and electrical codes and ordinances.
Do not short (jumper) across terminals on the gas valve or at the system control to test
installation. This will damage the thermostat and void the warranty.
Do not connect ground to any terminal in this unit.
This thermostat is equipped with automatic compressor protection to prevent potential
damage due to short cycling or extended power outages. The short cycle protection provides
a 5-minute delay between heating or cooling cycles to prevent the compressor from being
damaged.
Do not switch system to cool if the temperature is below 50°F (10°C). This can damage the
cooling system and may cause personal injury.
Use this thermostat only as described in this manual.

Advertisement

Table of Contents
loading

This manual is also suitable for:

9701i9715i9720i

Table of Contents