EMU26410
2-pin connector
AC 12 V-40/60/80W power is delivered
through this connector. When using it, keep
in mind the following points:
Use a genuine Yamaha connector.
G
Use lighting equipment only.
G
Connect lighting equipment directly to the
G
2-pin connector.
Capacity of the lighting equipment must be
G
more than 12 V-40/60/80W; otherwise the
bulb could burn out.
When the connector is not in use, place
G
the cap on it.
ECM01000
CAUTION:
Do not connect the 2-pin connector di-
rectly to the battery terminals. Otherwise
the electric system will be damaged.
EMU26801
Warning system
ECM00090
CAUTION:
Do not continue to operate the engine if a
warning device has activated. Consult
your Yamaha dealer if the problem can-
not be located and corrected.
EMU26817
Overheat warning
This engine has an overheat-warning de-
vice. If the engine temperature rises too high,
the warning device will activate.
Activation of warning device
The engine speed will automatically de-
G
crease to about 2000 r/min.
If equipped with an overheat-warning indi-
G
cator, it will light or blink.
The buzzer will sound (if equipped on the
G
tiller handle, remote control box, or main
switch panel).
ZMU04737
If the warning system has activated, stop the
engine and check the cooling water inlet for
clogging.
Basic components
ZMU03025
ZMU03026
18