The Remote Control Does Not Work; I Want To Change The Language For Messages And Menus - Epson EB-1965 User Manual

Problem Solving
Check
Is Output audio from the projector selected?
(Only when projecting USB Display)

The remote control does not work

Check
Is the remote control light-emitting area pointing towards the
remote receiver on the projector during operation?
Is the remote control too far from the projector?
Is direct sunlight or strong light from fluorescent lamps shining onto
the remote receiver?
Is the correct setting for the Remote Receiver selected?
Are the batteries dead or have the batteries been inserted correctly? Make sure the batteries are inserted correctly or replace the batteries with new ones if necessary.
When adjusting color difference using the multi-screen color
adjustment function, have you specified the correct projector ID for
the projector you want to operate?

I want to change the language for messages and menus

Check
Change the Language setting.
Click All Programs - EPSON Projector - Epson USB Display - Epson USB Display Vx.xx Settings, and then select
Output audio from the projector.
Point the remote control towards the remote receiver.
s "Remote control operating range"
The operating range for the remote control is about 6 m.
s "Remote control operating range"
Set the projector up in a location where strong light does not shine onto the remote receiver. Or set the remote receiver to
Off from Remote Receiver in the Configuration menu.
s Settings - Remote Receiver p.94
Check the Remote Receiver from the Configuration menu.
s Settings - Remote Receiver p.94
s "Replacing the remote control batteries"
While holding the [ID] button, press the number button that matches the ID of the projector you want to operate.
s "Setting an ID and using the remote control"
Adjust the Language setting from the Configuration menu.
s Extended - Language p.95
Remedy
Remedy
p.20
p.20
p.19
p.62
Remedy
124