Electro-Voice MA-1206 Instruction Manual And Users Manual page 8

18. "INPUT 1 ~ INPUT 10" Inputs
These ten balanced/unbalanced combination type jack (XLR and 6.3mm) input, Meant for
the connection of-condenser type microphone that accept 24V phantom power, dynamic
microphone (30-600ohms) or a high level sound source (e.g AM/FM tuner, cassette desk,
CD player, ect.) In case you are using , it is necessary to use the switch (20).
Balanced microphone
Unbalanced microphone
Balanced microphone
Unbalanced microphone
Note
Connecting unbalance microphones to the appliance when the phantom is switched on could
lead to severe damage on the microphones and is therefore not permissible. It is absolutely
mandatory to perform any plugging or unplugging of microphone cables with the phantom
power turned off. Also make sure that the phantom power is turned off when utilizing microphones
that are not meant to be operated with phantom power, The voltage that is present on pin2
and pin3 of the XLR-connector could lead to severe damages on the microphones. When in
doubt, contact your dealer before you perform any connections.
19. "INPUT 1 ~ INPUT 10" Inputs sensitivity and XLR phantom 24V switch
By turning this switches onto the "LINE" position the input can be connected to an audio source
with high level signal output. By turning these switches onto the "MIC" position, the input can be
connected to a dynamic microphone with low impedance. By turning these switch onto "24V"
position, connects the 24V phantom supply on XLR of pin2 and pin3 of inputs, necessary to
operate condenser type microphone which require this type of external supply. It is recommended
to use this switch with the general volume set on minimum.
2 1
3
3-pin XLR plug (seen from welded side)
2 1
3
3-pin XLR plug (seen from welded side)
Stereo jack
Mono jack
7