Seat Post Adjustment Knob - Schwinn 112 Parts List, Full Size Hardware Chart, Product Illustration, Assembly Instructions

Attach Seat Post, Slider, and Pad to Main Unit
Assembly Hardware Required:
1. Insert SEAT POST (#17) into corresponding hole in MAIN UNIT (#14). Tighten
down with SEAT POST ADJUSTMENT KNOB. (#16).
2. Insert SEAT (#21) onto SEAT SLIDER (#17). Tighten bolt on underside of the
seat with a wrench until seat no longer twists or tilts.
3. Seat Adjustment: Adjust the seat height by unscrewing seat post adjustment knob
and tightening into appropriate adjustment hole on the seat post. Leg should be
almost fully extended at the bottom of the pedal stroke. Fore and Aft seat position
can be adjusted with the seat slider knob. If the seat wobbles make sure that both
knobs (#16 and #30) are fully tightened.
Assembly Stage #3
NONE
page:10/16