Figure 29
3. Place the Front Right Log and the Center Left Log onto the 2 cor-
responding locating pins (each) as shown in Figure 30.
Center Left Log
Figure 30
4. Place the Front Left Log onto the 2 corresponding locating pins,
then place the Top Left Log onto the locating pin on the Left Center
Log (the log will rest in the corresponding indent on Rear Log). See
Figure 31.
Front Left Log Log
Figure 31
5. Place the Front Center Log in place as shown in Figure 32. The back
of the log fi ts into the corresponding indent on Rear Log.
14
Rear Log
Vermiculite
Front Right Log
Top Left Log
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Figure 32
6. Install the Top Right Log into the corresponding indentations on
Front Center Log and Front Right Log as shown in Figure 33.
Figure 33
7. Place the glowing embers on the burner as shown in Figure 34.
One package of ember material has been included with this log set
You will not need to use the entire bag.
IMPORTANT: The quantity and placement of the ember material can
affect stove performance therefore it is very important that it be placed
Figure 34
as shown in
.
a. Unpackage and divide the fi ne ember material (mineral wool) into
dime-sized fl uffy pieces.
b. Distribute the pieces over the top of the front burner area in front of
the forward logs (see Figure 34).
Figure 34
VERIFY THAT THE GAS LINE HAS BEEN PURGED OF AIR (See Step
10, page 11) .
Front Center Log
Top Right Log
Embers