Lennox Hearth Products Elite EDVI25 Installation Instructions Manual page 12

LOGS, VERMICULITE AND EMBERS - Models EDVI25 & EDVI30 (For
EDVI35 Log Installation Instructions, see Page 13).
The packaged log set, vermiculite and embers are located within the
fi rebox of the insert.
Installation Instructions:
WARNING: IF LOGS ARE NOT INSTALLED ACCORDING TO THE
DIRECTIONS SHOWN HERE, FLAME IMPINGEMENT AND IMPROPER
COMBUSTION COULD OCCUR AND RESULT IN SOOT AND/OR EXCES-
SIVE PRODUCTION OF CARBON MONOXIDE (CO), A COLORLESS,
ODORLESS, TOXIC GAS.
Notes:
• If an optional Brick Liner Kit was purchased, intall it now, per instruc-
tions provided in kit.
• Place some vermiculite around the burner as shown in Figure 28
before installing the logs (the entire bag of vermiculite will NOT be
used).
Carefully install the seven-piece log set into the fi rebox as shown in
these instructions. All logs should fi t onto corresponding pins and/or
log stoppers. This will ensure a proper fl ame and safe combustion.
1. Place the largest log onto the 2 corresponding locating pins at the
back of the fi rebox as shown in Figure 20.
Rear Log
Figure 20
2. Place the Front Right Log onto the 2 corresponding locating pins
as shown in Figure 21.
Figure 21 Front Right Log
12
3. Place the Center Log onto the 2 corresponding locating pins as
shown in Figure 22.
Figure 22
4. Place the Front Left Log onto the 2 corresponding locating pins as
shown in Figure 23.
Figure 23
5. Install the Top Left Log onto the corresponding locating pin and
indentation on Center Log as shown in Figure 24.
Figure 24
6. Install the Front Center Log over the Front Right Log . The front
of log will rest on the burner and the back of log will rest on rear log
as shown in Figure 25.
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Center Log
Front Left Log
Top Left Log