Advertisement
Section 10309 – Manufactured Electric Fireplaces
PART 2 EXECUTION
1.
INSPECTION
A.
B.
C.
2.
PREPARATION
A.
B.
3.
INSTALLATION
A.
B.
C.
D.
4.
PROTECTION
A.
B.
Do not begin installation until substrates have been properly prepared.
If substrate preparation is the responsibility of another installer, notify Architect of
unsatisfactory preparation before proceeding.
Verify proper power supply and fuel source are available.
Clean surfaces thoroughly prior to installation.
Prepare surfaces using the methods recommended by the manufacturer for achieving
the best result for the substrate under the project conditions.
Install in accordance with manufacturer's instructions and requirements of authorities
having jurisdiction.
Use manufacturer's guidelines for minimum clearances to combustibles, walls, and
finishes.
Anchor all components firmly in position for long life under hard use.
Upon completion of installation, visually inspect all exposed surfaces. Touch up
scratches and abrasions with touch up paint recommended by the manufacturer;
make imperfections invisible to the unaided eye from a distance of 5 feet (1.5 m).
Protect installed products until completion of project.
Touch-up, repair or replace damaged products before Substantial Completion.
Cat. No.
Notes
END OF SECTION
10309-3
Advertisement
