Planar LA1500R User Manual page 11

Connecting the display
To set up this display, please refer to the following fi gure and procedures.
1. Be sure all equipment is off .
2. Connect the DC power cord to the power connector. Plug one end of the
AC power cord into the power adapter, and the other end into an electrical
outlet(1).
3. Connect the VGA signal cable from display VGA input connector to the
15-pin VGA connector of your host computer and tighten the screws(2).
4. For the LA1500RTR or the LA1500RTS touch screen models confi gure the
touch screen. Refer to the "Touch Screen Driver Installation" section on
page 24.
5. Turn on your computer, display and video source.
Notice: To ensure the LCD display works well with your computer, confi gure
the display mode of your graphic card to less than or equal to 1024 x
768 resolution and make sure timing of the display mode is compat-
ible with the LCD panel. "Video Modes" of this LCD panel are listed in
the appendices for your reference.
LA1500R, LA1500RTR, and LA1500RTS User's Guide (
(Figure 1.1)
020-0319-03 Rev. A)
11