Electrical Connection - Zanussi ZCM5150 Instruction Book

The appliance can be connected to the gas
supply, right or left side, by one print of
connection. The end of the distributing pipe is
threaded.
It is necessary to route the connecting hose
(flexible) at the back of the appliance as shown in
the diagram. Ensure that the rubber hose is not
in contact with any part of the hatched area
shown in the diagram. The hose has to be fixed
in the support by means of the clamp supplied.
The hose should not have narrow curves or
throttlings. Check tightness with soapy water.

Electrical connection

Important
Any electrical work required to install
this hob should be carried out by a qualified
electrician or competent
accordance with the current regulations.
THIS COOKER MUST BE EARTHED.
The manufacturer declines any liability
should these safety
observed.
Before switching on,
electricity supply voltage is the same as that
indicated on the rating plate.
Note:
In case of a direct connection to the mains you
have to interpose an omnipolar switch a
minimum opening between contacts of 3 mm.
The switch should be sited within 2m of the hob
and be easily accessible upon completion of the
installation.
The yellow-green grounding cable has not to be
interrupted by the switch.
Ensure that the cooker supply cable does
not come into contact with any part of the
hatched area shown in the diagram.
NOTE : The earth wire should be about 2 cm
longer than the live and neutral wires.
Use the cable with the section indicated in the
table no.1.
Before connecting check that:
-
fuse and household electric installation can
bear the charge of the appliance (see rating
plate);
18
person, in
measures not be
make sure the
connection
of flexibile
hose
clamp
fig. 21
How to proceed?
•
Unscrew and remove the protective cover at
the back of the appliance;
•
Connect the power cord to the terminal of the
cooker according to the table no.1;
•
Fix by means of cable clamp;
•
Make sure that the connection to the terminal
is matching the network power;
•
Remount and screw the protective cover at
the back of the appliance.