Table of Contents
Advertisement
ICP-CP508 | User's Guide | 7.0 Panic Alarms
6.1
Standard Isolating: Method 1
Standard Isolating allows all users to isolate zones
without knowing a valid user code.
4. Press the [*] key twice to enter Isolating Mode.
Three beeps sound and the STAY indicator
flashes.
5. Enter the zone number (1 to 8), followed by
the [*] key (for example, [1 *] = Zone 1, [2 *]
= Zone 2).
Each zone to isolate has a corresponding zone
indicator that flashes.
6. If you select an incorrect zone to isolate, enter
the incorrect zone number again followed by
the [*] key.
7. Repeat Step 2 if you are isolating more than
one zone, until all zones to isolate are selected.
8. Press the [#] key after all selected zones are
isolated.
Two beeps sound and the system returns to the
disarmed state.
6.2
Code-based Isolating: Method 2
Code-based isolating requires a valid user code to
isolate a zone.
1. Press the [*] key once.
2. Enter your user code and press [*].
3. Enter the zone number that you want isolated,
followed by the [*] key.
4. Repeat Step 2 if more than one zone is
required to be isolated.
5. Press the [#] key after all selected zones are
isolated.
7.0 Panic Alarms
An audible alarm activates when the [1] and [3]
keys or the [*] and [#] keys are pressed
simultaneously. Contact your installer to disable
the ability to activate the codepad panic alarm or
to silence the codepad panic alarm.
8.0 Fire Alarms
An audible codepad Fire Alarm activates when
you press [4] and [6] on the remote codepad
simultaneously. A distinct fire sound emits through
the horn speaker to indicate this type of alarm.
Contact your installer to disable the ability to
activate the codepad panic alarm or to silence the
codepad fire alarm.
9.0 Medical Alarms
An audible codepad Medical Alarm activates
when you press [7] and [9] simultaneously.
Contact your installer to disable the ability to
activate the codepad panic alarm or to silence the
codepad medical alarm.
Bosch Security Systems, Inc. | 9/08 | F01U089856-01
10.0 Initiating Entry Warning
Hold down the [1] key for 2 sec. The codepad will
start beeping to indicate the entry warning timer
has started. At the end of the entry warning delay
time (15 sec), Zone 1 will go into alarm and the
internal sounder will emit a siren sound.
Entering a valid user code during entry warning
time disarms the system.
11.0 Changing the Codepad
Buzzer Tone
Hold down the [8] key on the codepad. The tone
of the buzzer will start to increase in pitch. Release
the [8] button when the desired tone is reached.
12.0 Specifications
Table 5:
Specifications
o
Temperature Range
0
C to +50
(+32
Humidity
20% to 90% (non-condensing)
11 VDC to 14VDC
Operating Voltage
Current Draw
50 mA (max)
RF Immunity (RFI)
Complies with AS/NZS3548
EN | 6
o
C
o
o
F to +122
F)
Hide quick links:
Advertisement
Table of Contents
