Operating Sequence - Zanussi DTI 6726 Instruction Booklet

Operating sequence

1. Check the filters
Ensure they are clean and properly
positioned (see cleaning instructions).
2. Check that there is rinse aid
and salt
3. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the
plates, saucers, glasses and cups etc. in it.
Slide the basket back into the machine.
4. Ensure that the spray arms can
rotate freely.
5. Measure out detergent
Add the required amount of detergent into
the dispenser according to the "Washing
programmes" chart and close the lid.
6. Close the detergent dispenser
lid
7. Set the programme
The selection of a programme occurs with
the door partially opened.
Turn the programme selector dial clockwise
until the letter of the programme you wish
to select corresponds with the programme
marker on the control panel.
If required press the "Economy 55°C"
button according to the instructions in
the "Washing programmes" chart (see
"Required pushbuttons").
8. Start the programme
Depress the On/Off button.
Close the door and the machine will start.
9. At the end of the washing
programme
At the end of the washing programme the
machine stops automatically.
10. Switch off the dishwasher
Open the door and switch off the
dishwasher by pressing the On/Off button.
When the wash programme has
finished, it is recommended that the
dishwasher is unplugged and the water
tap turned off.
In general it is not advisable to open the
door while the machine is working;if the
door is opened however, a safety device
ensures that the machine stops.
Caution
Do not open the door during the hot
phase: this may cause hot water
escape.
Care must be taken if the door is
opened during the hot phase or
immediately after a programme has
finished, as steam may escape.
37
POS04GB