Before Use; Setting The Water Softener - Zanussi DTI 6726 Instruction Booklet

Before use

Before using your dishwasher for the first time:
1. ensure that the electrical and water
connections comply with the installation
instructions
2. remove all packaging from inside the appliance
3. set the water softener
4. pour 1 litre of water inside the salt container and
then fill with salt
5. fill the rinse aid dispenser.

Setting the water softener

The dishwasher is equipped with a water softener
designed to remove minerals and salts from the
water supply, which would have a detrimental or
adverse effect on the operation of the appliance.
The higher the content of these salts, the harder
your water is.
Water hardness is measured in equivalent scales,
for example German, French degrees, and parts
per million.
The softener should be adjusted according to the
hardness of the water in your area. Your local
Water Authority can advise you on the hardness of
the water in your area.
The dishwasher is factory set at level 2.
If this level is not suitable for your area the softener
should be adjusted.
To adjust the water softener:
With a screwdriver turn the selector on the upper
front corner of the machine until the level required
corresponds with the marker.
Water hardness
German French
degrees
degrees
(°dH)
0-4
5-11
12-22 21-40
23-34 41-60
35-50 61-90
51-67
91-120
If your water hardness is below level 1 it
*
is already soft and therefore there is no
need to use salt.
In this case adjust the water softener on
level 1 without using salt.
5
AA05
29
PPM
Level
(Parts per
(°TH) million)
0-7
0-80
*
8-20
81-200
1
201-400
2
401-600
3
601-900
4
901-1200
5
Use of
salt
NO
SI
SI
SI
SI
SI
PBU01/2GB