Chapter 2: Board Installation - TYAN S7040 User Manual

Chapter 2: Board Installation

You are now ready to install your motherboard.
How to install our products right... the first time
The first thing you should do is reading this user's manual. It contains important
information that will make configuration and setup much easier. Here are some
precautions you should take when installing your motherboard:
(1) Ground yourself properly before removing your motherboard from the
antistatic bag. Unplug the power from your computer power supply and
then touch a safely grounded object to release static charge (i.e. power
supply case). For the safest conditions, TYAN
static safety wrist strap.
(2) Hold the motherboard by its edges and do not touch the bottom of the
board, or flex the board in any way.
(3) Avoid touching the motherboard components, IC chips, connectors,
memory modules, and leads.
(4) Place the motherboard on a grounded antistatic surface or on the antistatic
bag that the board was shipped in.
(5) Inspect the board for damage.
The following pages include details on how to install your motherboard into your
chassis, as well as installing the processor, memory, disk drives and cables.
Caution!
1.
To avoid damaging the motherboard and associated
components, do not use torque force greater than
(6.09 lb/in)
installation.
2.
Do not apply power to the board if it has been damaged.
http://www.TYAN.com
on each mounting screw for motherboard
17
®
recommends wearing a
7kgf/cm