Zanussi ZDW 416 FS Instruction Booklet

Dishwasher zdw 416 fs; zdw 416 bu

Advertisement

INSTRUCTION BOOKLET
DISHWASHER
ZDW 416 FS
ZDW 416 BU

Advertisement

Table of Contents
loading

Summary of Contents for Zanussi ZDW 416 FS

  • Page 1 INSTRUCTION BOOKLET DISHWASHER ZDW 416 FS ZDW 416 BU...
  • Page 2: Table Of Contents

    ...............page 15 TECHNICAL SPECIFICATIONS ZDW 416 FS ZDW 416 BU...
  • Page 3: Warnings

    Care must be taken to ensure that the appliance does not stand on the electrical supply cable or on the water inlet and drain hoses. Zanussi dishwashers are designed to be used for washing normal household utensils. Items that are contaminated by petrol, paint, steel or iron debris, corrosive, acidic or alkaline chemicals are not to be washed in a dishwasher.
  • Page 4: Installation

    Fitting a decor panel on the door You can move the worktop forward or backward by 25 (ZDW 416 FS - ZDW 416 BU) mm in order to align the machine with other kitchen The door of this machine has frames for fitting a units.
  • Page 5 Fitting under a counter Securing under a counter (ZDW 416 BU) (ZDW 416 BU) (kitchen worktop or sink) Open the door; vertically insert the two mounting brakets (A) on the front part of the dishwasher and This dishwasher is designed to be fitted under a kitchen turn them 90°...
  • Page 6 4 cm; hooked over the edge of the sink using the special curved plastic guide provided (ZDW 416 FS). CA02 CA03 The waste connection must be at a height of between...
  • Page 7: Use

    Control panel 1. Pilot light 5. Phase indicator guide This comes on when the ON/OFF button depressed, indicating that the machine is on. 6. Programme selector dial To select a programme, push the Programme Selector 2. ON/OFF pushbutton Dial clockwise, making sure that the programme letter you wish to select corresponds with the Green Marker on the window.
  • Page 8 Rinse aid Use of detergent The use of this liquid ensures thorough rinsing, spot Before starting any of the dishwashing programmes, and streak free drying, making the water run quickly except for the rinse and hold programme, load the off the dishes for sparkling results. It is automatically detergent in the dispenser.
  • Page 9 Loading your machine The cutlery basket is in two parts which can be separat- ed to give greater loading flexibility. To separate the two Before placing dishes in the machine, remove any parts, slide them horizontally in opposite directions and scraps of food from the plates (small bones, pull them apart.
  • Page 10: Adjusting The Height Of The Upper Basket

    Adjusting the height of the upper basket Use of the upper basket The upper basket is designed for plates (dessert If washing very large plates (over 27 cm and up to 31 plates, saucers, dinner plates up to 24 cm in diame- cm in diameter) you can load them in the lower ter), salad bowls, cups and glasses;...
  • Page 11: Helpful Hints

    HELPFUL HINTS For best washing results: Items not suitable for dishwashers The following should not be washed in the Before loading, remove all scraps of food and soak dishwasher: very heavily soiled pots and pans. Always arrange saucepans, cups and glasses etc. up Cutlery or dishes with wooden or horn handles or side-down.
  • Page 12: Washing Programmes

    WASHING PROGRAMMES Cycle Programme Degree of Soil Programme Required Recommended Quantity of Description Knob Type of load Pushbuttons Detergent Setting on the dispenser in the dispenser Heavy soil. Cold prewash INTENSIVE Crockery, Main wash up to 65°C 65° 30 g Cutlery 1 cold rinse Pots &...
  • Page 13: Operating Sequence

    Operating Sequence 6 Start the programme 1. Check that the filters are clean Depress the ON/OFF pushbutton . The pilot light will come on and the machine will start. (see cleaning instructions) If you wish to interrupt the wash at any time press the button again.
  • Page 14: Maintenance And Cleaning

    MAINTENANCE AND CLEANING Cleaning the central filters Internal and external cleaning (After each wash) You must ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned Inspect the central filters (B) and (C) and remove any regularly with a damp cloth.
  • Page 15: Servicing

    The water supply has been cut off. The inlet hose is kinked. If, after the above checks, the fault persists, call your local Zanussi Service Centre. Please make sure you The water inlet hose filter is clogged. give the model and serial number of the appliance.
  • Page 16 Printed in Italy 0/0897 152995 49/0...

Table of Contents