Table of Contents
Advertisement
CHECKING LID SHUT-OFF DEVICE
1. Lift the lid
2. Turn one hotplate tap to its full on position and
push the ignition button.
3. Close the lid. There should now be no gas
supply to the hotplate and the burner will go out.
4. Turn off the hotplate and lift the lid. The gas
supply should now be restored to the hotplate,
when the tap is turned on.
CHECKING THE MAIN OVEN
1. Turn on the oven thermostat control knob to
mark 9 and press the ignition button. As soon as
the burner is alight the button can be released.
2. There should now be a low gas rate to the
burner, which is the F.S.D by pass rate.
3. When the F.S.D. phial has heated up it opens
the F.S.D valve which allows the main gas
supply to the oven burner.
4. After 1 minute check that the flame covers the
full width of the burner and is stable.
5. Set the oven control to Mk 2, close the oven
door and check that after about 10 minutes the
flame size has reduced.
6. Turn off the control and check that the oven
flames go out.
GENERAL NOTE
Instruct the user on how to use the appliance and its
ignition system. Refer the user to the wording on the
inside cover which gives advice on the safe
operation of the appliance.
29
Advertisement
Table of Contents
