Table of Contents
Advertisement
2.4.5
Onboard Device Configuration
Phoenix-Award BIOS CMOS Setup Utility
Onboard Device Configuration
Select Menu
Item Specific HelpW»-
Onboard AC97 Audio
Onboard IAN
[Enabled]
[Enabled]
Press[Enter] to set
Onboard LAN Boot ROM.
[Disabled]
Serial. Portl Address
[3FB/IRQ4]
Serial Port2 Address
[2F8/IRQ3]
Parallel Port Address
Parallel Port Mode
[378/IRQ7]
[ECP]
X
EPP Mode Select
EPP1.7
ECP Mode Use DMA
[3]
SI: Help
n ! Solect Itc о
BSC: Exit
: Select Menu
• /+: Change Veluo
Enter: Select Sub- лш
F5: Setup Defaults
Е Ю : Save and Exit
OnChip IDE Device
The sub-menus contains IDE function-related items. Select an item then
press <Enter> to edit.
Phoenix-tard BIOS TOS f tup utility
OnChip IDE Device
Select Menu
*** On-Chip Serial ATA Setting ***
[23333
X
PATA IDE Mode
Primary
SATA Port
PI, P3 is Secondary
Item Specific Help»
Press[Enter] to set
El:Help
f j : Soloct Item
-/+: Change Value
F5: Setup Defaults
ESC: Exit
->«-: Select
fc-nu
Eftt c: Select Sub-menu
FIG: Save and Exit
On-Chip Serial ATA
[Auto]
Setting to [Disabled] disables the onchip Serial ATA controller. [Auto]
lets the BIOS auto-configure. [Combined Mode] enables PATA and
SATA, with a maximum of two IDE drives in each channel. [Enhanced
Mode] enables both PATA and SATA, supporting a maximum of six
IDE drives. [SATA Only] enables SATA to operate in legacy mode.
Configuration options: [Disabled] [Auto] [Combined Mode]
[Enhanced Mode] [SATA only]
2-58
Chapter 2: BIOS setup
Hide quick links:
Advertisement
Table of Contents
