Toshiba Satellite X200; Satellite X205 Maintenance Manual page 191

4 Replacement Procedures
3. Remove the heat sink from the VGA board by removing the four screws. Follow the
order indicated by the numbers on the heat sink in reverse to remove the screws.
Installing the VGA Board
To install the VGA board, follow the steps below and refer to the figure in the preceding
section:
CAUTION: If you remove the heat sink, use the grease tool to remove the grease on the
VGA board and heat sink. Reapply fresh grease before installing the heat sink.
1. Connect the heat sink to the VGA board by securing it with four screws. Follow the
order indicated by the numbers on the heat sink to tighten the screws.
2. Seat the VGA board and secure it by placing the three M2.5x4 screws and tightening
them.
4-56
Figure 4-67 Removing the VGA heat sink
[CONFIDENTIAL]
Satellite X200/ X205 Series Maintenance Manual
4.23 VGA Board