Toshiba Satellite X200; Satellite X205 Maintenance Manual page 168

4.11 Display Assembly
Installing the Display Assembly
To install the display assembly, follow the steps below and refer to the figures in the
preceding section.
1. Seat the display assembly, taking care not to crush to the LVDS cable or wireless LAN
antenna connectors.
2. Secure two M2.5x8 black screws to each hinge to connect the assembly on the top cover.
3. Secure two M2.5x8 black screws to the computer's rear side. They hold the display
assembly in place.
4. Replace the strip cover.
5. Connect the LVDS cable, function button board cable, wireless LAN antennas, CMOS
cable, and microphone cable to their respective sockets on the system board.
Satellite X200/ X205 Series Maintenance Manual
[CONFIDENTIAL]
4 Replacement Procedures
4-33