Building In - Zanussi ZGF 983 ITX Instruction Booklet

7. Building In

SR
A
ZGF 983 ITX
These hobs can be inserted in a built-in kitchen unit
whose depth is between 550 and 600 mm. The hobs
dimensions are shown in Fig. 9.
A = Auxiliary burner
R = Rapid Burner
FITTING THE LID
We recommend the lid hinge block are fitted
before installing the hob into the worktop.
To install the lid onto the hob, proceed as follows:
a. Remove the right and left hand grid blocks fitted to the
back of the hob, by unscrewing the relevant screws
(Fig. 10)
b. Fit the lid hinge blocks onto the hob, using the original
screws, ensuring that the relevant shims are fitted
between the hinge blocks and the hob (Fig. 10);
c. Fit the left hand lid hinge (marked S) into the hinge block
(Fig.11);
d. Carry out the same operation with the right hand lid
hinge (marked D).
ADJUSTING THE LID BALANCE
To adjust the lid balance, turn clockwise or anti-clockwise
the central screw of the right- and left-hand hinges (Fig.
12).
UR
SR
R
SR = Semirapid burner
UR = Triple Crown Burner
A
Fig. 9
SR
UR
SR
R
ZGF 983 ITXC
Fig. 11
Fig. 10
Fig. 12