Start The Programme; End Of Programme - Zanussi ZWU 6120 Instruction Booklet

7. Select the DELAY START
Before you start the programme, if you wish the
starting to be delayed, press the DELAY START
button repeatedly, or keep it pressed, to select the
desired delay. The selected delay time value (up to
24 hours) will appear on the display for 3 seconds,
then the duration of the programme will appear
again.
During this period it is possible to load other laundry:
• depress START/PAUSE button;
• load the laundry;
• close the door and depress START/PAUSE button
again

8. Start the programme

Press the START/PAUSE button. The relevant light
will stop flashing, and only the light relevant to the
phase that is in progress will remain lit.
If you have chosen a delayed start, the machine will
begin the countdown.
The display will show the duration of the programme
or the selected delay.
If the DELAY START option has been selected,
the machine begins the countdown. The display
shows the duration of the programme or the
delayed time.
9. How to change an option or a
programme during its cycle
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause the
washing machine by pressing the START/PAUSE
button.
Changing a running programme is possible only by
resetting it. Turn the programme selector dial to
"OFF" and then to the new programme position. The
washing water in the tub will not emptied out .
10.How to open the door during
the cycle of a programme
You can open the door, after having set the machine
to PAUSE, provided the following conditions exist:
• the machine is not in the heating phase beyond
55°C;
• the level of the water is not high;
If these requirements are met, when you pause the
machine, the door locked light goes off and the door
can be opened.
Should it not be possible to open the door, and
should it be absolutely necessary to do so, switch
the machine off turning the programme selector to
position OFF.
After approximately 3 minutes, you can open the
door.
Pay attention to the level and temperature of the
water in the machine!
Select the programme again and depress the
START/PAUSE button.

11. End of programme

At the end of the programme, the machine stops
automatically, the START/PAUSE button light and
the door locked light go off, the END pilot light
illuminates, the display shows a blinking zero and the
door can be open.
The door can be opened when the END light
illuminates and the the door locked light
goes off.
Switch the machine off by turning the programme
selector dial to position OFF.
Remove the laundry from the machine.
17