Setup Flowchart - Yamaha CRW6416S Series Owner's Manual

Setup Flowchart

This flowchart shows the procedure for setting up the CRW6416S drive. For
easy cross-referencing, the relevant pages in this manual are also given.
STEP
Do you have a SCSI adapter
1
card?
Check that the SCSI adapter
STEP
2 card is installed correctly
Go to Control Panel | System | Device
Manager tab. Double-click on SCSI
controllers and check that the adapter
card has been installed correctly.
Set up the CRW6416S drive
STEP
3
1. Set the jumper switches (P.10)
2. Fit the drive into the computer
Tower-type case (P.14)
As additional or replacement drive
Desktop-type case (P.22)
As a replacement drive
Check that the CRW6416S
STEP
4 drive is installed correctly
Go to Control Panel | System | Device
Manager tab. Double-click on CDROM
and check that the drive has been
installed correctly.
Install the CD writing software
STEP
5
For details about how to install the
software, refer to the manual that comes
with it.
Start using the CRW6416S
STEP
6 drive!
Use the drive to create audio CDs, to
back up data on your hard disk, or for
whatever purpose suits your needs.
NO
YES
1
STEP
Obtain a SCSI adapter card
1-1
Recommended models:
Adaptec AHA2940-series (PCI)
Install the SCSI adapter card
STEP
1-2
Read this manual and insert the
SCSI card into the appropriate
PCI slot on the computer.