Handlebar Switches - Yamaha BIG BEAR 4X4 Owner's Manual

EBU00053

Handlebar switches

1. Light switch " / /OFF"
2. Engine stop switch "
3. Start switch " "
EBU00849
Engine stop switch "
Make sure that the engine stop switch is in the
" " position. The engine stop switch controls
ignition and can be used at all times to stop
the engine, especially in an emergency. The
engine will not start or run when the engine
stop switch is turned to "
"/" "
"/" "
".
EBU00607
Start switch "
The starter motor cranks the engine when this
switch is pushed.
CAUTION:
_
See starting instructions prior to starting
the engine. (See page 6-1 for details.)
_
EBU01058
Light switch "
Set the switch to the "
the low beam and the tail/brake light. Set the
switch to the "
beam and the tail/brake light. Set the switch to
the "OFF" position to turn off all the lights.
CAUTION:
_
Do not use the headlights with the engine
turned off for more than thirty minutes.
The battery may discharge to the point
that the starter motor will not operate
properly. If this should happen, remove
the battery and recharge it.
_
4-5
"
/ /OFF"
" position to turn on
" position to turn on the high