Handlebar Switches - Yamaha WOLVERINE YFM45FXV Owner's Manual

Odometer and tripmeter modes
Pushing the "SELECT" button switches the
display between the odometer mode "ODO"
and the tripmeter mode "TRIP" in the following
order:
ODO→TRIP→ODO
To reset the tripmeter, select it by pushing the
"SELECT" button, and then push the "SE-
LECT" button for at least two seconds. The
tripmeter can be used to estimate the dis-
tance that can be traveled with a full tank of fu-
el. This information will enable you to plan
future fuel stops.
NOTE:
_
Pushing in the "SELECT" button, then turning
the key to "ON", and keeping them in this po-
sition for at least two seconds switches the
display between "mph" and "km/h".
_
EBU00053

Handlebar switches

1. Light switch " /
2. Engine stop switch "
3. Start switch " "
EBU12040
Light switch "
Set the switch to "
and the taillight.
Set the switch to "
beam and the taillight.
Set the switch to "OFF" to turn off all the lights.
4-4
/OFF"
/ "
/ /OFF"
" to turn on the low beam
" to turn on the high