Transmission Oil - Yamaha BLASTER YFS200P Owner's Manual

EBU00835

Transmission oil

Transmission oil measurement
1. Place the machine on a level place.
2. Warm up the engine for several minutes,
and stop it.
3. Check the oil level through the level win-
dow located at the right side crankcase
cover.
NOTE:
Wait a few minutes until the oil level settles
before checking.
4. The oil level should be between the maxi-
mum and minimum marks. If the level is
low, add oil to raise it to the proper level.
Transmission oil replacement
1. Place the machine on a level place.
2. Warm up the engine for several minutes,
and stop it.
3. Place a container under the engine.
4. Remove filler cap and drain bolt to drain
the oil.
5. Install the drain bolt and tighten to specifi-
cation.
Tightening torque
Drain bolt:
20 Nm (2.0 m0kg, 14 ft0lb)
6. Fill the engine with oil and install the filler
cap.
q
1. Level window
3. Minimum level mark
8-5
q
w
e
2. Maximum level mark