Yamaha YZF-R6 Owner's Manual page 26

INSTRUMENT AND CONTROL FUNCTIONS
To reset a tripmeter, select it by push-
ing the "SELECT" button, and then
push the "RESET" button for at least
one second. If you do not reset the fuel
reserve tripmeter manually, it will reset
itself automatically and the display will
return to the prior mode after refueling
and traveling 5 km.
3
Clock mode
Turn the key to "ON".
To change the display to the clock
mode, push the "SELECT" button for at
least one second.
To change the display back to the prior
mode, push the "SELECT" button.
To set the clock:
1. Push the "SELECT" button and
"RESET" button together for at
least two seconds.
2. When the hour digits start flashing,
push the "RESET" button to set
the hours.
3. Push the "SELECT" button, and
the minute digits will start flashing.
4. Push the "RESET" button to set
the minutes.
5. Push the "SELECT" button and
then release it to start the clock.
Self-diagnosis devices
This model is equipped with a self-di-
agnosis device for various electrical cir-
cuits.
If any of those circuits are defective,
the engine trouble warning light will
come on, and then the multi-function
display will indicate a two-digit error
code (e.g., 11, 12, 13).
This model is also equipped with a self-
diagnosis device for the immobilizer
system.
If any of the immobilizer system circuits
are defective, the immobilizer system
indicator light will flash, and then the
multi-function display will indicate a
two-digit error code (e.g., 51, 52, 53).
3-9
NOTE:
_
If the multi-function display indicates
error code 52, this could be caused by
transponder interference. If this error
appears, try the following.
_
1. Use the code re-registering key to
start the engine.
NOTE:
_
Make sure there are no other immobi-
lizer keys close to the main switch, and
do not keep more than one immobilizer
key on the same key ring! Immobilizer
system keys may cause signal interfer-
ence, which may prevent the engine
from starting.
_
2. If the engine starts, turn it off, and
try starting the engine with the
standard keys.
3. If one or both of the standard keys
do not start the engine, take the
vehicle, the code re-registering
key and both standard keys to a
Yamaha dealer and have the stan-
dard keys re-registered.