Tail/Brake Light; Replacing A Turn Signal Light Bulb - Yamaha YZF-R6 Owner's Manual

After removal Before installation
1. Quick fastener
2. Pin
NOTE:
_
To install the quick fastener, push the
center pin out so that it will protrude
from the fastener head, insert the fas-
tener into the auxiliary light bulb cover,
and then push the protruding pin in until
it is flush with the fastener head.
_
PERIODIC MAINTENANCE AND MINOR REPAIR

Tail/brake light

This motorcycle is equipped with an
LED type of tail/brake light.
If the tail/brake light does not come on,
have a Yamaha dealer check it.
6-44
EAU03730
1. Screw
Replacing a turn signal light
bulb
1. Remove the turn signal light lens
by removing the screw.
2. Remove the defective bulb by
pushing it in and turning it
counterclockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screw.
CAUTION:
@
Do not overtighten the screw, other-
wise the lens may break.
@
EAU03497
6
ECA00065