Weslo WLTL29606.1 User Manual page 9

7. Set the Console (91) face down on a soft sur-
face to avoid scratching it. Hold the Right
Handrail (33), which has a large hole in the loca-
tion shown, near the Console.
Next, insert the console wire into the large hole
in the side of the Right Handrail (33). Using
needlenose pliers, grasp the tie inside the Right
Handrail and pull the connector to the hole near
the bracket on the Right Handrail. Carefully
grasp the connector with the pliers and pull the
console wire out of the hole.
8. Set the Right Handrail (33) on the Console (91).
Make sure that the console wire is not
pinched. Start a 16mm Screw (85) with an M5
Star Washer (7) into the Right Handrail, and
then start two 19mm Screws (10) into the Right
Handrail. Tighten the 16mm Screw and then
tighten the two 19mm Screws; do not over-
tighten the Screws.
Attach the Left Handrail (not shown) to the
Console (91) in the same way. Note: There is
not a console wire on the left side.
7
Console Wire
Bracket
33
91
8
Console Wire
33
91
9
Tie
Connector
Large
Hole
85
7
10