Table of Contents Thank you for purchase this unit. Please read this owner’s manual carefully before use and keep it at a safe place for your future reference. Table of Contents 1. Table of Contents ....................1 2. Precautions ......................2 3.
Precautions Before operating this unit, check the voltage of this unit to see if it is identical with the voltage of your local power supply. Unplug the unit from the wall outlet if it is not used for a long time. To disconnect the cord, pull it out by grasping the plug.
Control Locations The unit For model no.: IP10 i-Pod Player (Not supplied) Handle -- Set the alarm --- Set clock --------- Previous Tuning backward / Channel select backward --------- Play / Pause / Stop Memory Stations --------- Next Tuning forward / Channel select forward --------- Standby -- Function mode select LED Display lens...
Page 5
For model no.: IP20 i-Pod Player (Not supplied) Handle -- Set the alarm --- Set clock --------- Previous Tuning backward / Channel select backward --------- Play / Pause / Stop Memory Stations --------- Next Tuning forward / Channel select forward...
Installation Batteries Caution: Be careful when you press the slot of the battery compartment with your fingernails only as this might break them. 1. Press the lock on the battery compartment. 2. Press the slot on the battery compartment. 3. Pull out the battery compartment. 4.
Turning the Power On and Off Insert the AC/DC adapter’s DC plug into the unit, then insert one side of AC power cord into a wall outlet, and your unit is at your command! This unit has a built-in Recharge Li-lon battery, you can also insert the AC/DC adapter’s DC plug into the unit for charging, the indicator will light up.
Using the Unit Listening to music from an i-Pod (i-Pod player is not supplied): 1. Place the appropriate corresponding universal i-Pod adaptor, included with i-Pod, into this unit i-Pod docking location, then connect your i-Pod. 2. Press the button for 2 seconds or more. A LED will indicate that the unit is on. 3.
Press the ) button once or more to skip forward one or more tracks of the disc. Press and hold the ) button to search for the position that you intend to start playing. 7. Press the button on the remote in playing mode, all sound will be muted. Press the button again or +/- buttons on the remote or rotate the volume control knob on the front of unit to resume sound.
Note: The operating time of every step shouldn’t be longer than 5 seconds or it will return to the original display. If the unit is unplugged or if a power failure occurs, the preset stations will not be erased. Preset Tuning (Possible only after presetting stations) Repeatedly press the ) buttons to select the desired preset number.
Setting the Clock Manually The built-in clock shows the time on the display. 1. In standby mode, press the button for 2 seconds or more, the hour indicator will blink on the LED. 2. Set the hour with rotate the volume control knob on the front of the unit or +/- buttons on the remote.
Setting the Alarm The alarm time indicator “ ” is displayed of the LED display when you turn the alarm on, however the clock must be set correctly for the timer function to work. 1. In standby mode, press and hold the button for 2 seconds or more to enter alarm set mode.
Trouble shooting Troubles Reasons Solutions The unit can’t be AC/DC adapter isn’t plugged into Plug the AC/DC adapter into turned on. (AC Operation) a wall outlet or the connector isn’t a wall outlet and plug the plugged into the power supply jack connector into the power sup- on the back of the unit.