Operating Sequence - Zanussi ZIDW 954 Instruction Booklet

Operating Sequence

1. Check that the filters are clean
(see cleaning instructions)
2. Depress the ON/OFF pushbutton
The number corresponding to the first selectable
programme appears in the display.
3. Check that there is rinse aid
4. Load the dishes
Remove larger scraps of food.
Pull the lower basket out and arrange the saucepans,
plates and cutlery in it.
Pull the upper basket out and arrange the plates,
saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
Ensure that the spray arms can rotate freely.
5. Measure out detergent
Pour the required amount of detergent into the
dispenser according to the indications in the Washing
Programmes chart and close the lid.
A self adhesive label summarising your dishwasher's
programmes is supplied with the instruction book.
We recommend that you stick it to the top edge of the
dishwasher's door for easy reference.
6. Set the programme
PROGRAMME
SELECTOR
SO69
The following options may also be selected:
- ECONOMY DRY by pressing the relevant button.
The pilot light corresponding to the selection made
comes on.
- DELAY START by pressing the relevant button
until the required number of hours' delay is set.
Press the programme
selector button until the
number corresponding to
the required programme
appears in the display. The
pilot light continues to flash
until the programme is
started.
7. Starting the wash programme
Open the water tap.
Close the dishwasher door.
An audible signal lasting about 1 second informs you
that the programme has been started.
If a delayed start has been selected, the dishwasher
starts the countdown and the number of hours to go
before the programme starts appears in the display. A
flashing dot indicates that the function is active. Once
the set delay has elapsed, the programme starts
automatically.
If you wish to interrupt the wash programme at any
time, press the ON/OFF
machine, press this button again and the wash
programme will resume at the point at which it was
interrupted.
8. At the end of the wash programme
The machine stops automatically. An intermittent
audible signal lasting about 5 seconds informs you
that the programme has finished. A flashing
pears in the display. This signal remains until the
programme selector button is pressed.
Switch of the dishwasher by pressing the ON/OFF
button.
Turn off the water tap.
Wait a few minutes before removing the dishes; in this
way they will be cooler and the drying will be
improved.
Empty the lower basket first and then the upper one;
this will avoid water dripping from the upper basket
onto the dishes in the lower one.
9. Cancel the wash programme
To cancel a wash programme which is running, press
the «CANCEL» button until the short «instruction
accepted» signal (about 2 seconds) is heard. The
number indicating the first selectable programme
appears in the display and the programme selector
light flashes: the previous setting has been cancelled
and a new programme can now be selected.
PSO08GB
11
button. To restart the
ap-