Toshiba Portege R100 User Manual page 94

A bar will appear only under the selected device.
3. Use the left/right cursor keys to highlight the boot device you want
and press Enter.
1. If a supervisor password is set, the menu above does not appear when
you use the user password to start the computer.
2. The selection method above does not change the boot priority
settings in HW Setup.
3. If you press a key other than one of those above or if the selected
device is not installed, the system will boot according to the current
setting in HW Setup.
4. Support of PCA (ATA) card boot is guaranteed only for TOSHIBA PC
card HDDs.
5. A PCA (ATA) card takes the position of HDD in the Boot Priority
Options list.
Network Boot Protocol
This feature sets the protocol to remotely boot from the network.
[PXE]
[RPL]
HDD Priority Options
This option sets the priority for booting the computer from the HDD.
Select from the following settings:
Built-in HDD
−> PC Card
(Default)
PC Card
−> Built-in HDD
Keyboard
Wake-up on Keyboard
When this feature is enabled and the computer is in Standby mode, you
can turn on the computer by pressing any key. It is effective only for the
internal keyboard and only when the computer is in standby mode.
Enabled
Disabled
Portégé R100
Sets PXE as the protocol. (Default)
Sets RPL as the protocol.
The computer will look for the Built-in HDD first,
next to the PC Card (Default).
The computer will look for the PC Card first, next
the Built-in HDD.
Enables Wake-up on Keyboard.
Disables Wake-up on Keyboard. (Default)
HW Setup
7-4