Advertisement
INSTALLATION THE FLEXIBLE SHAFT AND
BITS
Switch machine OFF and remove the electric cord
from the power source.
Remove the cover and mount the fl exible
shaft.(See Fig.13)
Insert the fl exible shaft wrench in the hole of the
handle to stop the rotation of the shaft.
Turn the collet nut until the fl exible shaft wrench
engages the hole in the shaft. (See Fig. 14)
Insert the bit into the collet to prevent the bit from
coming out of the tool while in use.
Tighten the collet nut securely with wrench
provided. (See Fig. 15)
Remove the fl exible shaft wrench.
OPERATING THE FLEXIBLE SHAFT
Follow these guidelines when operating the tool.
Always allow the tool to operate as it was
designed. Never force the fl exible shaft .
Clamp or otherwise secure the work to prevent it
from shifting.
Hold the tool tightly and keep it a safe distance
from users. Always point the bit away from your
body.
Ensure that ventilation openings are kept clear
when working in dust conditions. If it is necessary
to clear dust of inside parts, disconnect the tool
from the power supply fi rst and avoid damaging
internal parts.
Slow speed is best for polishing operations,
delicate woodcarving, or working on fragile model
parts.
High speed is suitable for operation on hardwoods,
metals and glass, such as: carving, routing,
shaping, cutting and drilling.
AFTER OPERATION
Do not touch the moving part when the fl exible
shaft is just switched off.
Do not put down your tool before the working
head stops rotating.
WARNING:
Always remove the electric cord from the
power source before changing grinding wheel,
brushes, lubricating or when working on the
unit to avoid possible serious injury.
WARNING:
This electric tool is in accordance with the
relevant safety requirements. To assure safety
and reliability, all repairs should performed by
an Authorised Service Centre.
ADJUSTMENTS
MAINTENANCE
The tool must be switched off and unplugged before
making any maintenance of the accessories.
Clean out all accumulated work dust after
operation. The air-vent of the tool should be
cleaned regularly to avoid overheating of the motor
which is caused by the block of the air-vent.
Don't clean the tool set with water, as no liquid is
allowed to drip into the tool body, clean the tool
only with a dry clean cloth.
Keep handles dry, clean and free from oil and
grease.
Don't allow petroleum based products to come
into contact with the plastic parts of the tool,
as they contain chemicals that can damage or
destroy the plastic parts.
Use only with sharp scroll saw blades and ensure
cutting/grinding accessories are also sharp.
Inspect all mounting screws and ensure they are
properly tightened regularly.
If anything improper happens during operation,
the power supply should be cut off at once. And
the tool should be checked and repaired by
authorized Ryobi service centre.
When replacement is necessary, use original
spare parts from authorized Ryobi service centre.
Store the tool in a cool and well-ventilated area.
Keep the tool away from direct sunlight.
Page 11
Advertisement
