Connecting To Your Computer - Verbatim QUAD INTERFACE User Manual

and then double click the setupx fi le to start installation. The nero installation window will appear. Follow
up the set up wizard to install the software. Note: nero BackItUp Software is only compatible with Windows
2000 / XP / and Vista.

Connecting to your computer

This Verbatim external hard drive provides four available connection protocols: eSATA, USB, FireWire 400, or
FireWire 800. You can attach your drive to a computer with any of these connections, but do not attempt to
use more than one connection type at the same time.
Connecting your drive to a computer is extremely simple. Follow the steps below:
1. Connect the included AC power cord to the drive, and then to a wall outlet.
2. Next press the ON/OFF switch on the back of the drive to the ON position.
3. Finally, connect one, and only one, of the following data cables.
USB: Connect the included USB cable from the USB port on the drive to an available USB port on your
computer.
FireWire 400: Connect the included 6-pin-to-6-pin FireWire cable from the FireWire 400 port on the
drive to an available FireWire 400 port on your computer.
FireWire 800: Connect the included 9-pin-to-9-pin beta cable from on of the FireWire 800 ports on the
drive to an available FireWire 800 port on your computer.
eSATA: Connect the included eSATA cable from the eSATA port on the drive to an available eSATA
port on your computer.
4. The hard drive will mount automatically, and a new icon will appear in
new icon will appear on the desktop (Mac). Depending on your computer's operating system and the
interface type you are using, the following special notes may apply
Depending on your computer's operating system and the interface type you are using, the following special
notes may apply:
5
My Computer (Windows) or a