Operating Sequence - Zanussi ZTI 6100 Instruction Book

Operating sequence

1. Check the filters
Ensure they are clean and properly positioned
(see "Maintenance and cleaning").
2. Press the On/Off push button
The display will show the last selected
programme (if with the last programme options
have been selected the corresponding indicator
lights will illuminate).
3. Check that there is rinse aid
and salt
The corresponding indicator lights will illuminate
if refilling is necessary.
4. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the
plates, saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5. Ensure that the spray arms can
rotate freely.
6. Measure out detergent
Add the required amount of detergent into the
dispenser.
Close the detergent dispenser lid.
Important!
If the half load option is selected remember
to reduce the quantity of detergent.
7a. Setting and starting the
programme without "delay
start"
The selection of the programme occurs with
the door partially opened.
Press the "programme selector" push button
until the required programme number
appears in the digital display.
To see the duration of the programme (in
minutes), only with open door, press the
"cancel" push button
The following options may also be
selected:
a- Half load: by pressing the corresponding
push button
b- Eco drying/no drying by pressing the
corresponding push button.
Close the door, the programme will start
automatically and an audible signal advises
you of this. All the indicator lights will turn
off.
The display will show the running time
of the programme.
40
SEQ34en