1. Manuals
  2. Brands
  3. Zanussi Manuals
  4. Dishwasher
  5. ZT 415
  6. Instruction booklet

Zanussi ZT 415 Instruction Booklet

Zanussi instruction booklet dishwasher zt 415
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
INSTRUCTION BOOKLET
DISHWASHER
ZT 415

Advertisement

Table of Contents
loading

Related Manuals for Zanussi ZT 415

Summary of Contents for Zanussi ZT 415

  • Page 1 INSTRUCTION BOOKLET DISHWASHER ZT 415...

  • Page 2: Table Of Contents

    CONTENTS Warnings ...............page Installation .

  • Page 3: Warnings

    Children should not be allowed to tamper with the controls or play with the product. During Use Zanussi dishwashers are designed to be used for washing normal household utensils. Items that are contaminated by petrol, paint, steel or iron debris, corrosive, acidic or alkaline chemicals are not to be washed in a dishwasher.

  • Page 4: Installation

    INSTALLATION Remove all packaging before positioning the machine. Positioning If possible, position the machine next to a water tap and a drain. The dishwasher features fill and drain hoses which can be turned either to the left or the right to suit the installation .

  • Page 5: The Electrical Connections

    The cover/carrier is indicated by the coloured in- sert at the base of the plug. A replacement cover/carrier must be obtained from your local Zanussi Service Force Centre whose address is listed in the Customer Care Booklet which accompanies your instruction manual.

  • Page 6: Use

    Control panel THE CONTROLS In this fully integrated appliance the controls are located on the top of the door. When selecting a programme, the door needs to be partially opened. Audible signals have been introduced to help indicate which operations the dishwasher is performing. Short «instruction accepted»...
  • Page 7 The Water Softener Water contains varying amounts of lime and mineral salts depending on the area in which you live: these are deposited on the dishes leaving white marks. The higher the content of these salts, the harder your water will be. The «hardness» level is measured on 2 equivalent scales: Clarke degrees or French degrees.
  • Page 8 If the hardness of your water is as low as 6 Clarke degrees. This will avoid lime deposits on crockery and the inner tub. Zanussi recommends the use of Finish dishwasher detergent. PBR13GB...
  • Page 9 Loading your Machine Before placing dishes in the machine, remove any scraps of food from the plates (small bones, toothpicks, fish bones, scraps of meat and vegetables, fruit skins etc.) to avoid clogging the filters and consequently reducing performance. Open the door and slide out the baskets to load the dishes.

  • Page 10: Adjusting The Height Of The Upper Basket

    Adjusting the Height of the Upper Basket If washing very large plates (over 27 cm and up to 31 cm in diameter) you can load them in the lower basket after moving the upper basket to the higher position as follows: Move the front runner stops (A) of the upper basket out- ward and slide the basket...

  • Page 11: Washing Programmes

    WASHING PROGRAMMES Type of load and Programme degree of soil RINSE & HOLD INTENSIVE Heavily soiled crockery, 70°c pots, pans and cutlery Normally soiled crockery, NORMAL pots, pans, and cutlery, 65°c Lightly soiled crockery, ECONOMY pots and cutlery 55°c Lightly soiled crockery QUICK WASH 55°c...

  • Page 12: Operating Sequence

    OPERATING INSTRUCTIONS 1 Check that the filters are clean (see cleaning instructions) 2 Switch on the appliance at the mains supply. 3 Check that there is salt and rinse aid 4 Load the dishes Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it.

  • Page 13: Maintenance And Cleaning

    MAINTENANCE AND CLEANING Cleaning the Central Filters (After each wash) Inspect the central filters (B) and (C) and remove any scraps of food with a brush, under running water. Filters (B) and (C) are both removed by lifting up the outer one (B) (pulling the central funnel upwards);...

  • Page 14: Servicing

    SERVICING Certain problems are often due to lack of simple maintenance or oversights and can be solved easily without having to call out an engineer. If the machine will not start The door has not been properly closed. The plug is not properly inserted in the power socket. There is no current at the socket.
  • Page 15 Please note that proof of purchase is required for any guarantee service calls. Service detail - adhesive label When you return your guarantee card to Zanussi Ltd., you will receive a «Appliance Guarantee And Maintenance Record» together with an adhesive label (containing the telephone number of your local Zanussi Service Centre).

  • Page 16: Building-In

    BUILDING-IN Building-in features This dishwasher is designed to be fitted under a kitchen counter or sink. In either case, it is essential that the recess dimensions indicated in the picture are followed. No further openings for venting of the dishwasher are required, but only to let the water fill and drain hoses and power supply cable pass through.
  • Page 17 Securing under a counter Secure the dishwasher to the counter on the front part by means of two 4,2x13 screws provided (see fig. - point A). II03 Important! The dishwasher must be secured against tilting. Therefore, make sure that the counter it is fitted under, is suitably secured to a fixed structure (adjacent kitchen cabinets, wall).

  • Page 18: Peace Of Mind For Twenty Four Months

    This guarantee is in addition to your statutory and other legal rights. We, Zanussi Ltd., undertake that if, within twentyfour months of the date of the purchase, this ZANUSSI appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we...
  • Page 20 152995 81/0 Printed in Italy 0/1096...

Table of Contents