Operation - Ryobi 4710300 Operator's Manual

PREPARING FOR CUTTING
See Figure 3.
Place the workpiece in the desired position against
the saw's miter fence.
Loosen the knob bolt.
Slide the miter clamp down against the workpiece
as shown.
Tighten the knob bolt securely. As the knob bolt
tightens, pressure against the post causes the
miter clamp to pull the workpiece inward against
the miter fence and down toward the table. As
noted above, the miter clamp pulls the workpiece
inward up to 1/16 in.
WARNING
This clamping device provides assistance only; the
operator must ensure control of the workpiece at all
times. Failure to heed this warning could cause an
accident resulting in serious personal injury.

OPERATION

TO
RAISE
TO
LOWER
WORKPIECE
5
MITER CLAMPING KIT
INSTALLED
POST
TO
LOOSEN
KNOB BOLT
MITER CLAMP
MITER FENCE
TO
TIGHTEN
Fig. 3