Cleaning The Appliance - Smeg Fridge-freezer User Manual

Cleaning the appliance

Before cleaning, disconnect the appliance from the power
mains – rotate the thermostat knobs A (and B) to position
and unplug the power cord.
• Use a soft cloth to clean all surfaces. Cleaners containing
abrasive particles, acids, or solvents, are not appropriate
as they will damage the surface.
Clean the appliance exterior with water or a mild solution of
suds.
Lacquer-coated and aluminum surfaces can be cleaned with
lukewarm water to which some mild detergent was added.
Cleaning agents with minor alcohol content are also acceptable
(e.g. window cleaners).
Cleaners with alcohol content are not allowed for cleaning plastic
parts.
Clean the appliance interior with lukewarm water to which you
may add some vinegar.
• Placed under the cooling board that cools the refrigerator
interior are a trough (groove) and an opening through which
melted water is discharged from the appliance interior. The
through and the opening should never be blocked; therefore,
check them often and clean as required (e.g. using a plastic
straw).
• Frost and ice accumulated in a layer of 3-5 mm will cause
an increase in power consumption; therefore it should be
removed regularly (this does not apply to the NO FROST
freezer). Do not use any sharp objects, solvents, or sprays.
• Condenser unit on the back of the refrigerator should always
be kept clean, free of dust or deposit from kitchen smoke. Use
a soft non-metal brush or a vacuum cleaner to clean the dust
periodically.
• Also clean the container above the refrigerator compressor. If
it was removed for cleaning, replace it afterwards. Make sure
the container is in a horizontal position!
• After cleaning, switch on the appliance and put the food back
in.
29