Set-Up And Safety - Grundig Cosmopolit 3M WEB User Manual

SET-UP AND SAFETY

Please note the following instructions when set-
ting up the system:
The device is designed for the playback of
7
audio signals. Any other use is expressly pro-
hibited.
If you want to set up the device on wall
7
shelves or in cupboards, please ensure that
it is adequately ventilated. There must be at
least 10 cm of space at the side, above and
behind the device.
Do not cover the device with newspapers,
7
table cloths, curtains, etc.
When setting up the device, remember that
7
furniture is often coated with various types of
varnish and plastic, which often contain chemi-
cal additives. These additives may cause cor-
rosion to the feet of the unit. This may leave
stains on the surface of the furniture which can
be difficult or impossible to remove.
If the device is exposed to sudden changes in
7
temperature, for example when taken from the
cold into a warm room, wait at least two hours
before using it.
The device is designed for use in dry rooms.
7
If you do use it outdoors, make sure it is pro-
tected from moisture such as dripping or
splashing water.
Only use the device in a moderate climate.
7
Do not place the device close to heating units
7
or in direct sunlight, as this will impair cooling.
Do not place any vessels containing liquids,
7
such as vases, on the device.
Do not place any objects such as burning can-
7
dles on the device.
Do not open the device casing under any cir-
7
cumstances.
Warranty claims are excluded for damage re-
7
sulting from improper handling.
-----------------------------------------------------------------------------------------------
Thunderstorms are a danger to all electrical
7
devices. Even if the device is switched off, it
can be damaged by a lightning strike to the
mains or the antenna cable. Always discon-
nect the mains during a storm.
Continuous use at high volume level can cause
7
damage to the user's hearing
If malfunctions occur due to static electricity
7
charges or brief mains voltage surges, reset
the device. To do this, pull out the mains
adapter and connect it again after a few sec-
onds.
Where the main plug or an appliance coupler
7
is used as the disconnect device , the discon-
nect device shall remain readily operable.
Note:
Do not connect any other equipment while
7
the device is switched on. Switch off the oth-
er devices as well before connecting them.
Only plug the device into the mains socket
after you have connected the external de-
vices. Make sure the power plug is freely
accessible.
39
ENGLISH