Harman Kardon AVR 147 Owner's Manual page 29

System Configuration
After one input has been adjusted for analog or
digital input, speaker type and surround mode,
return to the line on the
INPUT SETUP
menu and enter the settings for each
MASTER
input that you will use. In most cases, only the
digital input and surround mode may be different
from one input to the next, while the speaker
type will usually be the same (inputs set to
). But if prefered you can also select
GLOBAL
different speaker types or turn speakers on or off
individually for each input in use.
Once the settings outlined on the previous pages
have been made, the AVR is ready for operation.
While there are some additional settings to be
made, these are best done after you have had an
opportunity to listen to a variety of sources and
different kinds of program material. These system
settings are described on pages 39 to 40 of this
manual. In addition, any of the settings made in
the initial configuration of the unit may be
changed at any time. As you add new or different
sources or speakers, or if you wish to change a
setting to better reflect your listening taste,
simply follow the instructions for changing the
settings for that parameter as shown in this
section.
Note that any settings changed at any time, also
when the discrete buttons are used only, will be
stored in memory in the AVR, also if it´s turned off
completely, unless it will be reset (see page 45).
Having completed the setup and configuration
process for your AVR, you are about to
experience the finest in music and home-
theater listening. Enjoy!
SYSTEM CONFIGURATION 29