Pride Mobility Flash Owner's Manual page 24

V . C O M F O R T
Controller Position
You can position the controller for either left-hand or right-
hand use.
WARNING! Do not place the controller
cable so that it can be pinched in the
seat frame or the power base frame.
To change the controller position:
1. Unplug the controller connector and the charger inhibit
connector from the main harness. See figure 7.
2. Cut the wire tie(s) that attaches the controller cable to
the armrest.
3. Flip up the armrest and loosen the setscrew. See figure 16.
4. Slide the controller out of the armrest.
5. Loosen the setscrew in the other armrest.
6. Place the controller in the other armrest.
7. Tighten the setscrew to secure the controller.
8. Use a wire tie to secure the controller cable to the armrest.
9. Plug the controller connector and the charger inhibit
connector into the main harness. See figure 7.
Swing-away Footrests
Swing-away Footrests (SFRs) enable you to rotate the footrests
to the side before you transfer onto or off of your power chair.
To rotate the SFRs:
1. Push in the release lever. See figure 17.
2. Rotate the SFRs.
To adjust the SFR length:
1. Remove the hardware from the side of eachfootrest
extension. See figure 17.
2. Slide the footrest up or down to the desired length.
3. Reinstall the hardware.
24
A D J U S T M E N T S
SETSCREW
Figure 16. Underside of Armrest
FOOTREST
EXTENSION
Figure 17. Swing-Away Footrests
www.pridemobility.com
RELEASE LEVER
FOOTREST
HARDWARE
Flash/RevC/Jan04