Advanced Features; Colour, Brightness And Contrast; Auto Scan; Sleeptimer - One for All URC-7510 User Manual

Hide thumbs

Table Of Contents

Table of Contents

Colour, Brightness and Contrast

Depending on the functions of your original remote control, the ONE

FOR ALL may operate the colour, brightness and contrast settings of

your television.

Colour up

Colour down

Brightness up

Brightness down = Press and release MAGIC then hold Channel (-)

Contrast up

Contrast down

Note: You have 5 seconds to press the Volume, Channel or Menu keys after

pressing MAGIC.

Auto Scan

Your ONE FOR ALL comes with a special Scan function which lets you

scan through every channel available on your television.

To scan the channels on your TV:

Aim the ONE FOR ALL at your TV. Press and release MAGIC then

press the MUTE key.

The ONE FOR ALL will send the command to advance through all

the channels available on your television stopping at each channel

for about three seconds. Remember, you must aim the ONE FOR ALL

at your device the entire time you are using Scan.

When you find a channel you would like to watch, simply press any

key.

Note: Auto Scan may not work with devices that not have Channel +/- keys

on the original remote control.

Sleeptimer

If your television has a "Sleeptimer" function built in, you can access

this function with your ONE FOR ALL remote. To do so:

Make sure your television is switched on (not in standby).

Point the ONE FOR ALL at your television and press and release

MAGIC then press POWER. You should see the Sleeptimer activate

on your TV screen.

To increase the timer, simply press MAGIC then POWER again until

the timer gets to the desired time.

To deactivate the Sleeptimer, repeat steps 1-3 above. During step 3,

continue pressing MAGIC and POWER until the timer indicates zero

minutes.

Note: Depending on how you used sleeptimer on the original remote, you

might need to access sleeptimer in a different way (through menu

for example).

WWW.ONEFORALL.COM