Checking The Propeller Shaft Housing; Checking The Propeller Shaft; Assembling The Propeller Shaft Assembly - Yamaha F90D Service Manual

Slide hammer 2: YB-06096
Bearing puller legs 3: YB-06523
3. Remove the oil seals and needle bear-
ing.
Bearing housing needle bearing
remover 4:
YB-06153
Driver handle (large) 5: YB-06071

Checking the propeller shaft housing

1. Clean the propeller shaft housing using a
soft brush and cleaning solvent, and then
check it for cracks. Replace if necessary.
2. Check the teeth and dogs of the reverse
gear for cracks or wear. Replace the
gear if necessary.
3. Check the bearings for pitting or rum-
bling. Replace if necessary.

Checking the propeller shaft

1. Check the propeller shaft for bends or
wear. Replace if necessary.
2. Measure the propeller shaft runout.
6D81G11
3. Check the dog clutch and slider for
cracks or wear. Replace if necessary.
Assembling the propeller shaft
assembly
1. Install the dog clutch as shown.
NOTE:
Install the dog clutch 1 with the "F" mark a
facing toward the slider.
S6D56510
Propeller shaft housing
Runout limit: 0.02 mm (0.0008 in)
1
2
3
4
5
6
7
8
9
6-12