General Control - Sharp XL-E100H(BK) Operation Manual

General control

RRMCGA22 RRMCGA226 AWS A
To turn the power on
Press the ON/STAND-BY button to turn the power on.
After use:
Press the ON/STAND-BY button to enter the power
stand-by mode.
Display brightness control
To dim the display brightness, press the DEMO/DIMMER
button on the remote control.
(Display is dim).
Dimmer 1
(Display gets dimmer).
Dimmer 2
(Display is bright).
Dimmer off
Volume illuminator
When the power is turned on, volume illuminator lights
up.
To turn on/off the light, hold down the DEMO/DIMMER
button on the remote control for more than 2 seconds.
Volume auto fade-in
If you turn off and on the main unit with the volume set to
27 or higher, the volume starts at 16 and fades in to the last
set level.
Volume control
Turn the volume knob towards VOL +/– (on main unit) or
press VOLUME +/– (on remote control) to increase or
decrease the volume.
Auto power on function
When you press any of the following buttons, the unit turns
on.
CD, USB, AUDIO / LINE (INPUT), TUNER (BAND) on
the remote control: Selected function is activated.
/ button on the main unit: The unit turns on and play-
back of the last function will start (CD, TUNER, USB,
AUDIO IN, LINE IN)
Auto power off function
The main unit will enter the stand-by mode after 15
minutes of inactivity during:
CD / USB: In the stop mode.
TUNER: No reception of broadcast signal.
AUDIO IN / LINE IN: No detection of input signal or very
low sound audibility.
Volume illuminator
The volume is muted temporarily when pressing the MUTE
button on the remote control. Press again to restore the
volume.
When the power is first turned on, the unit will enter the
extra bass mode which emphasises the bass frequencies,
and "X-BASS" will appear. To cancel the extra bass mode,
press the X-BASS button on the remote control.
1
2
1
2
When the EQUALIZER MODE button is pressed, the
current mode setting will be displayed. To change to a
different mode, press the EQUALIZER MODE button
repeatedly until the desired sound mode appears.
When the FUNCTION button on main unit is pressed, the
current function will change to different mode. Press the
FUNCTION button repeatedly to select desired function.
Note:
The backup function will protect the memorised function
mode for a few hours should there be a power failure or the
AC power lead becomes disconnected.
E-6
Muting
X-Bass control
Bass control
Press the BASS/TREBLE button to select "BASS".
Within 5 seconds, press the VOLUME (+ or –) button to
adjust the bass.
Treble control
Press the BASS/TREBLE button to select "TREBLE".
Within 5 seconds, press the VOLUME (+ or –) button to
adjust the treble.
Equaliser
Equaliser off.
Flat
For game
Game
For classical music
Classic
For pop music
Pops
Vocals are enhanced
Vocal
For jazz
Jazz
Function
FM STEREO
CD
Line In Audio In
FM MONO AM
USB