Energy Conservation Settings; Auto Power-Off At A Designated Time; Auto Power-Off After The End Of Broadcast; Auto Power-Off When There Are No Operations Performed - Sharp AQUOS LC-37A65M Operation Manual

Watching TV

Energy conservation settings

Auto power-off at a designated time

This function is conveniently used when, for instance,
going to bed while watching TV.
Press SLEEP.
1
• Remaining time displays when sleep timer has
been set.
Sleep timer: Remain 2hr. 00min.
Each time you press SLEEP, the remaining
2
time switches as shown below.
0hr. 30min.
Off
NOTE
• When the time has been set, countdown automatically
starts.
• Five minutes before the preset of time expires, the
remaining time displays each minute.
• Select "Off" by pressing SLEEP to cancel the sleep timer.
28
1hr. 00min. 1hr. 30min.
2hr. 30min. 2hr. 00min.

Auto power-off after the end of broadcast

You can set the TV to automatically power off in about
15 minutes after the TV goes into a state of receiving
no programme signals, such as the end of a broadcast
day.
Press MENU and the MENU screen displays.
1
Press c / d to select "Power Control".
2
Press a / b to select "No Signal Off", and then
3
press ENTER.
Press c / d to select "Enable".
4
• Five minutes before the power shuts down, the
remaining time displays every minute.
NOTE
• "Disable" is the factory preset value.
• When a TV programme fi nishes, and the TV receives signal
input, this function may not operate.
Auto power-off when there are no
operations performed
You can set the TV to automatically power off when no
TV operation is performed for more than 3 hours.
Press MENU and the MENU screen displays.
1
Press c / d to select "Power Control".
2
Press a / b to select "No Operation Off", and
3
then press ENTER.
Press a / b to select "30min." or "3hr.".
4
• Five minutes before the power shuts down, the
remaining time displays every minute.
NOTE
• "Disable" is the factory preset value.