Table of Contents
Advertisement
Menu operations
DNR (Digital Noise Reduction)
Menu Operation: A (page 12)
Produce a clearer image. (Off, High, Low)
HDMI Setup
HDMI (High-Definition Multimedia Interface) terminal
selection.
1
To watch an HDMI equipment image, select
"EXT5" or "EXT6" (the terminal which you are
using) from "INPUT SOURCE" menu using b
on the remote control unit or TV.
2
Press MENU and the MENU screen displays.
3
Press c/d to select "Option".
4
Press a/b to select "HDMI Setup", and then
press OK.
• "HDMI Setup" is displayed only when "EXT5" or
"EXT6" is selected from the INPUT SOURCE menu.
[ Option ... HDMI Setup ]
MENU
Option
Audio Only
DNR
HDMI Setup
5
Press a/b to select the desired item, and then
press OK.
6
Press a/b/c/d to select the desired setting, and
then press OK.
HDMI Setup
Selectable items
items
Signal
RGB/YCbCr 4:4:4/
Type*
YCbCr 4:2:2
Colour
ITU601/ITU709
Matrix*
Dynamic
Normal/
Range*
Enhanced
Auto View
Disable/Enable
Audio
Digital/Analogue
Select**
NOTE
• Refer to your external equipment operation manual for
the signal type.
• Items marked * may be greyed out (with 4) depending
on the type of signal input from the external equipment.
• Item marked ** is only available when EXT5 is selected.
TV/DTV/AV only
AV only
[Off]
Description
Select the video signal
type from the HDMI
terminal.
Select the internal colour
space conversion method
when an RGB signal is
input.
Select the signal amplitude
range. Usually, select
"Normal".
Set whether or not to use
WIDE MODE based on
signal recognition,
including an HDMI signal.
Select "Digital" for audio
signal via the HDMI
terminal. Select "Analogue"
for audio signal via the
AUDIO jack.
Input Select
Menu Operation: A (page 12)
For setting the signal type of external equipment.
Input source
Signal type
EXT 1
Y/C, CVBS, RGB
EXT 2
Y/C, CVBS, RGB
EXT 3
Rear
CVBS, S-VIDEO
Side
CVBS
EXT 4
PC (RGB), COMPONENT (Y, P
NOTE
• If no (colour) image displays, try to change the other
signal type.
• Check the operation manual of the external equipment
for the signal type.
• TV, EXT5 and EXT6 are not displayed in Input Select.
• If both CVBS and RGB signals are input to EXT 1 or EXT 2
using a SCART cable, the TV may output an RGB signal
even though you have designated CVBS for the respective
terminal. This happens due to the setting of your external
equipment.
• EXT 3 has "Rear" and "Side" terminals. Confirm which
terminal you have connected, and select the appropriate
terminal under "Input Select". When using S-VIDEO, select
"Rear" for EXT3.
Colour System
Menu Operation: A (page 12)
You can change the colour system to one that is
compatible with the image on the screen. (AUTO, PAL,
SECAM, NTSC3.58, NTSC4.43, PAL-60)
NOTE
• Factory preset value is "AUTO".
• If "AUTO" is selected, colour system for each channel is
automatically set. If an image does not display clearly,
select another colour system (e.g. PAL, SECAM).
• "NTSC3.58", "NTSC4.43" and "PAL-60" cannot be
selected in TV tuner mode.
, P
)
B
R
TV/AV only
19
Hide quick links:
Advertisement
Table of Contents
