Lock; Sort; Erase Programme; Child Lock - Sharp Aquos LC-32RD2E Operation Manual

Menu operations

Lock

You can block the viewing of any channel.
NOTE
• See "Child Lock" for setting PIN.
• When Lock is set to "On" for a channel, "Child lock has
been activated." displays, and the image and sound of
the channel are blocked.
• When pressing OK while "Child lock has been activated."
displays, PIN input menu will display. Inputting the correct
PIN lifts the child lock temporarily until the power is turned
off.

Sort

Channel positions can be sorted freely.
1
Repeat steps 1 to 4 in Programme Setup.
2
Press c/d to select "Yes", and then press OK.
3
Press a/b/c/d to select the channel you want
to move, and then press OK.
4
Press a/b/c/d to move it to the desired
position, and then press OK.
5
Repeat steps 3 and 4 until all desired channels
are sorted.

Erase Programme

An individual programme can be erased.
1
Repeat steps 1 to 4 in Programme Setup.
2
Press c/d to select "Yes", and then press OK.
3
Press a/b/c/d to select the channel you want
to erase, and then press OK.
• A message screen pops up.
4
Press c/d to select "Yes", and then press OK to
erase the selected programme. All the subsequent
programmes move up.
5
Repeat steps 3 and 4 until all desired channels
are erased.

Child Lock

Allow you to use a PIN to protect certain settings from
being accidentally changed.
Changing the PIN
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Setup".
3
Press a/b to select "Child Lock", and then press
OK.
Change PIN
Reset
TV only
New PIN – – – –
Reconfirm – – – –
4
Enter the 4-digit number as a PIN using 0 – 9.
5
Enter the same 4-digit number as in step 4 to
confirm.
• "The system PIN has been changed successfully"
displays.
NOTE
• To view a locked channel, you must enter a PIN. (See this
page and page 27 for locking channels from viewing in
analogue TV and DTV mode.) When you select a locked
channel, a PIN prompt message pops up. Press OK to
display the PIN input window.
Resetting the PIN
Allow you to reset your PIN to the factory preset "1234".
1
Repeat steps 1 to 3 in Changing the PIN.
2
Enter the PIN.
3
Press a/b to select "Reset", and then press OK.
4
Press c/d to select "Yes", and then press OK.
NOTE
• As a precautionary measure, make a note of your PIN
on the back of this operation manual, cut it out and
keep it in a safe place that children cannot reach.
• See page 32 for resetting the current PIN to the factory
preset "1234" if you lose or forget your PIN.

Input Label

You can assign each input source a label you like.
1
Press b to select the desired input source.
2
Press MENU and the MENU screen displays.
3
Press c/d to select "Setup".
4
Press a/b to select "Input Label", and then press
OK.
5
Press a/b/c/d to select each character of the
new name for the input source, and then press
OK.
6
Repeat step 5 above until the name is fully spelt
out, and then press OK.
• The name can be 6 characters or less.
• If a label name is less than 6 characters, select
"END", then press OK.
NOTE
• You cannot change the label if the input source is TV or
DTV.
17